Re: [aclug-L] Funny problem with /etc/fstab

[John Goerzen <jgoerzen@xxxxxxxxxxxx>]

"Bates, Rod" <Rod.Bates@xxxxxxxxxxxxxxxxxx> writes:

> Here it is: 
> >>>>

OK, I'm going to assume that the wrapping here was caused by your mail 
software?  (Ie, the "user,noaut,defualts 0 0" after /dev/fd0 is not on 
a separate line).  Also, the ">>>>" and "<<<<" aren't part of the file?

> /dev/hda2                 /                         ext2   defaults 1 1
> /dev/hda1                 /dos                      msdos  defaults 0 0

The last number ought to always be "2", except for /, which should be 1.

> /dev/hdb1                 /home2                    ext2   defaults 1 2
> /dev/sda1                 /home                     ext2   defaults 1 2
> /dev/sdb1                 /jaz1                     ext2   defaults 0 0
> /dev/sdc1                 /jaz2                     ext2   defaults 0 0

Same applies here.

> /dev/hda7                 /local                    ext2   defaults 1 2
> /dev/hdc                  /cd                       iso9660 user,noauto,ro
> defaults 0 0

And here.  You also need a comma between iso9660 and user, and between 
ro and defaults (note that defaults is rather superflous here).

> /dev/fd0                  /dfd                      msdos
> user,noauto,defaults 0 0

Again, need 2 atthe end.

> /dev/fd0                  /fd                       ext2
> user,noauto,defaults 0 0

Same here.  Also, it's not a good idea to list a single device twice.

> #allegheny:(pid4551)       /net                      ignore 0 0 0
> #allegheny:(pid963)        /net                      ignore 0 0 0
> #allegheny:(pid244)        /net                      ignore 0 0 0
> #allegheny:(pid240)        /net                      ignore 0 0 0
> #allegheny:(pid245)        /net                      ignore 0 0 0
> /dev/hda6                 /usr                      ext2   defaults 1 2
> /dev/hda3                 none                      ignore 0 0 0

Not sure what this is here fore...

> 
> none                      /proc                     proc   defaults

You are missing the "0 0" at the end of this line.

> /dev/hda5                 none                      swap   sw

You need to have a "0 0" at the end of this line.

> 
> cwilan-sun:/opt10/b1b     /b1b                      nfs    soft,intr,rw
> salsv6:/salm04_dua2       /devel-bates              nfs    soft,intr,rw
> morley:/usr               /morley-usr               nfs    soft,intr,rw
> morley:/usr2              /morley-usr2              nfs    soft,intr,rw
> morley:/usr3              /morley-usr3              nfs    soft,intr,rw
> salsv6:/morley_sys6       /morley-usr4              nfs    soft,intr,rw
> salsv6:/morley_usr5       /morley-usr5              nfs    soft,intr,rw
> salsv6:/salm03_dua1       /prod-bates               nfs    soft,intr,rw


You're missing a "0 2" at the end of all of these lines.