[aclug-L] Re: Linux Router Project?

[David Carmichael <dec2955@xxxxxxxxxx>]

Will "PK" run from a floppy?
----- Original Message -----
From: "Abdul Basit Khatri" <basit@xxxxxxxxxxxx>
To: <discussion@xxxxxxxxx>
Sent: Thursday, April 26, 2001 3:33 PM
Subject: [aclug-L] Re: Linux Router Project?


>
> Hi you can try pklinux instead of LRP
> pklinux can be found at
> http://www2.linuxpakistan.net/pklinux/
>
> It can run on your 486 with 8MB  ram ..
> and you can configure it for your devices!
>
> hope this helps
> Basit
>
> On Fri, 27 Apr 2001, David Carmichael wrote:
>
> >
> > Does anybody here know of the 'Linux Router Project'.  The "Screen
Savers'
> > have spoke of it.
> >     (enough 'Linux' on a single 1.44 floppy to load, configure hardware,
and
> > work as a broadband router)
> >
> > If so... have you installed it?
> >
> > Here is the deal..
> >
> > My stepfather has an old IBM 486 50mhz which either the IDE controller
has
> > gone bad or the harddrive has gone bad.
> >
> > We have tried to install a new (800mb) harddrive and it would not work.
> > Tried a new IDE controler card, but could not disable the onboard IDE so
> > could not boot from the new card....
> >
> > This system has 64meg of the old 30pin simms, which he had paid a good
chunk
> > of change for.... and would really hate to trash the system.
> >
> > Anybody point me to the web site in question.
> >
> > --David
> >
> > -- This is the discussion@xxxxxxxxx list.  To unsubscribe,
> > visit http://tmp2.complete.org/cgi-bin/listargate-aclug.cgi
> >
> >
>
> -- This is the discussion@xxxxxxxxx list.  To unsubscribe,
> visit http://tmp2.complete.org/cgi-bin/listargate-aclug.cgi
>
>

-- This is the discussion@xxxxxxxxx list.  To unsubscribe,
visit http://tmp2.complete.org/cgi-bin/listargate-aclug.cgi