Complete.Org: Mailing Lists: Archives: discussion: May 2002:
[aclug-L] Re: Case Screws?
Home

[aclug-L] Re: Case Screws?

[Top] [All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index] [Thread Index]
To: <discussion@xxxxxxxxx>
Subject: [aclug-L] Re: Case Screws?
From: "Randi" <rsee@xxxxxxxxxxx>
Date: Sat, 25 May 2002 07:18:49 -0500
Reply-to: discussion@xxxxxxxxx

If you can not find them elsewhere try Hupp Hardware on Harry around
Washington they specialize in screws and bolts ect.

-----Original Message-----
From: discussion-bounce@xxxxxxxxx [mailto:discussion-bounce@xxxxxxxxx]
On Behalf Of David Carmichael
Sent: Friday, May 24, 2002 8:51 AM
To: discussion@xxxxxxxxx
Subject: [aclug-L] Re: Case Screws?
Importance: Low


Trouble is the outlet store is not open on Fridays any more...

They were in a cup...

Can you say...

In reverse order...
Cup of screws upside down on air vent...
Motherboard manual hits cup
Screwdriver hits motherboard manual
keyboard hits screwdriver
keyboard on top of monitor fall off
monitor cable is hit by cat
wife opens door and cat runs into room.

--  David

----- Original Message -----
From: "Joseph L Weaver" <jlweaver@xxxxxxx>
To: <discussion@xxxxxxxxx>
Sent: Friday, May 24, 2002 8:23 AM
Subject: [aclug-L] Re: Case Screws?


> Check the outlet store of National Computer.  They sell them in
packages.
These
> screws do not have normal threads.  Use a small plastic cup to hold
the
screws
> when you are working on computers
> ========================================
> David Carmichael wrote:
>
> > Ok all have a good laugh....
> >
> > While working on my mothers system I had one of those 'freak'
accidents
> > where in the short of it the 'case screw' ended up down an air vent
and
can
> > not be recovered....
> >
> > Well the holes/threads of the holes were enlarged/stripped due to
the
number
> > of times that the case had been opened and closed.
> >
> > But where is the best place in the Wichita area to get replacement
screws???
> >
> > The current screws were about a "#4" or "#6" Hex/Phillips heads.. so
I
> > figure that I now need the next size up...   But doing a quick look
at
> > 'Sutherlands' and 'Wal-Mart's all they have on hand are #10's which
are
too
> > large.
> >
> > --David
> >
> > -- Binary/unsupported file stripped by Ecartis --
> > -- Type: image/jpeg
> > -- File: Notebook.jpg
> >
> > -- This is the discussion@xxxxxxxxx list.  To unsubscribe,
> > visit http://www.complete.org/cgi-bin/listargate-aclug.cgi
>
>
> -- This is the discussion@xxxxxxxxx list.  To unsubscribe,
> visit http://www.complete.org/cgi-bin/listargate-aclug.cgi
>
>


-- This is the discussion@xxxxxxxxx list.  To unsubscribe,
visit http://www.complete.org/cgi-bin/listargate-aclug.cgi


-- This is the discussion@xxxxxxxxx list.  To unsubscribe,
visit http://www.complete.org/cgi-bin/listargate-aclug.cgi


[Prev in Thread] Current Thread [Next in Thread]