Re: [aclug-L] PnP sound in 2.2.2

[Jesse Kaufman <kaufmjes@xxxxxxxxxxxxxxxxx>]

i don't know much about PnP and kernel stuff, but i have been very satisfied
with ALSA's (alsa.jcu.cz) sound drivers...  it supports quite a few cards
(including my AudioPCI es1370 card), and (with my card) seems to work a
little better anyway...

jesse

j m wagle wrote:

> I finally got a new version of linux installed and still no sound.
> according to the documentation that came with the kernel, my OP931M
> sound card is a 'plug and play'.  all I know is that when this
> computer had windoz the sound was loud with the following settings:
> 220, irq 7, dma 0
>
> the following was from a pnpdump.
>
>   (CONFIGURE OPT0931/-1 (LD 0
>   #     ANSI string -->AUX0<--
>   # (ACT Y)
>   ))
>   #
>   # Logical device id OPT9310
>
>  # (IO 2 (BASE 0x0220))
>  #       Logical device decodes 16 bit IO address lines
>  #             Minimum IO base address 0x0e0c
>  #             Maximum IO base address 0x0ffc
>  #             IO base alignment 4 bytes
>  #             Number of IO addresses required: 4
>  # (IO 3 (BASE 0x0e0c))
>
> pnpprobe returned a short error message :(
>
> has anyone had any luck with linux pnp programs?
> where is a good source for information?
>
> any help will be appreciated.
>
> mike wagle,
> wichita.
> ---
> This is the Air Capital Linux Users Group discussion list.  If you
> want to unsubscribe, send the word "unsubscribe" to
> aclug-L-request@xxxxxxxxxxxx.  If you want to post to the list, send your
> message to aclug-L@xxxxxxxxxxxx.

--
"If we don't stand up to Micro$oft, who will?"
     - The Boycott Micro$oft Web Page

http://www.boycott-ms.org/



---
This is the Air Capital Linux Users Group discussion list.  If you
want to unsubscribe, send the word "unsubscribe" to
aclug-L-request@xxxxxxxxxxxx.  If you want to post to the list, send your
message to aclug-L@xxxxxxxxxxxx.