[linux-help] Re: loading RH 7.1

["adithya" <adithya111@xxxxxxxxx>]

Hi
What I think you should do is first to remove the master hard disk and plug
the other one as the master hard disk and then install if you want to be
safe.
IF not read the installation how to before you proceed and also remember
that your second hard disk will be hdb if its a IDE and Sdb if its a scsi
and if its the slave hard disk.
good luck.
regards,
Sudharsha.
-----Original Message-----
From: Marc Bachman <mbachman@xxxxxxxxxxxxx>
To: linux-help@xxxxxxxxx <linux-help@xxxxxxxxx>
Date: Thursday, May 31, 2001 7:29 PM
Subject: [linux-help] loading RH 7.1


>
>Thanks in advance- I am trying to load RH on a slave hard drive and when
>I get done with the manual partition RH says I have "native Linux " and
>"Linux swap " partitions but the install hangs. It may have been because
>I stopped the auto partition when I figured out it was installing to a
>DOS partition on my master drive. Any suggestions on how to proceed from
>here. And I wanted to say Thank You, Ben Bunck, for the help. I hope to
>see you soon. Marc Bachman
>
>-- This is the linux-help@xxxxxxxxx list.  To unsubscribe,
>visit http://tmp2.complete.org/cgi-bin/listargate-aclug.cgi
>
>


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com

-- This is the linux-help@xxxxxxxxx list.  To unsubscribe,
visit http://tmp2.complete.org/cgi-bin/listargate-aclug.cgi